How To Install a Garage Door the old door of the garage should be first removed using the instructions in the manufacturer’s manual, this is undertaken by unlatching the door from its pulley system, before unscrewing the tracks, the door panels are set apart, one panel is removed at a time so that it does not fall on someone measurement of the areas where the door is to be installed first takes place, these areas include the door opening height and width, the headroom and the back room, after measurement, to both sides of the opening, stops are attached, they should flush with the inside edge of the door jamb, the bottom piece of the new door is then laid out using sawhorses, additionally weather stripping may be attached, hinges attached and handles lifted to piece the bottom piece is then inserted into the door frame using a level in order to set it properly, having set the piece in place, the tap nails partway into each jamb, the nails should be bent slightly or slant to secure them in place, the vertical, curved and horizontal pieces of the track are then assembled using manufacturer’s instructions and the set aside The second panel is then installed on top of the first one, nails are then hammered into the side jambs so that they are well held in place, hinges are the next installed, then the process is repeated according to the number of panels that are necessary, however, it is a requirement that each of the pieces is anchored into the door jamb, this marks the completion of the fourth step undertaken when installing a garage door
What Almost No One Knows About Repairs
After all the sections are secured, the rollers are then installed in the section that supports the rollers, when that is done, the rollers are then placed in the previously assembled track, the brackets of the tracks are secured as one goes along, however, caution should be taken not to press the rollers exceedingly tight against the track, this is to avoid friction because it can cause damage to the door which will end up destroying the door eventually during usage
Lessons Learned About Services
after securing the vertical tracks against the jambs, the horizontal and curved pieces are installed next, previous measurements are used during installation of the horizontal pieces, the tracks should be straight and point 90 degrees away from the opening, springs are then assembled according to manufacturer’s instructions, in order to make the tracks level and parallel, the door is lifted to about half length, in order to attach springs to the pulley, the door is lifted up the remaining distance, that is how a new garage door is opened